|
Post by zuludon on Feb 20, 2020 5:24:42 GMT
I have to admit to being somewhat sloppy in the past regarding removing flash from my figures before I paint; but after one of the people who paints figures for me pointed out the large amount of flash on the figures from a certain small scale plastic manufacturer, it became clear that I could no longer ignore the issue. I have tried using a sharp X-acto blade but find I often end up cutting into the figure by accident. I recently bought an adjustable soldering iron from China and, after burning myself a couple of times, I have yet to determine whether it's more efficient than the old X-acto blade method. It seems to work for a while but when I pull the tip away from the figure, it leaves dozen of tiny threads that I then have to cut off. I also tried the paperclip heated over a candle methid, but that just left a blackened mess along the edges. What do other people use and is the problem simply a lack of patience and/or skill on my part?
Nick Stern
|
|
|
Post by davel on Feb 20, 2020 7:58:22 GMT
I use a scalpel blade. Always better when they're new. But of course, like Nick, I tend to puncture my skin with annoying frequency - amazing how sharp those scalpel blades are. A friend if mine uses a new scalpel and scrapes at the mould line quite quickly and says it gets the offending article off easily. Seems yo work quite well on ACTA and SIP, but not do well on the material they use for Expeditionary Force figures.
|
|
|
Post by Mike Blake on Feb 20, 2020 13:25:15 GMT
FWIW I too have tried exacto, scalpel, soldering iron, sanding pads/sticks, and combinations of all the above. I have reached two conclusions - sharp blade (one for every box,unit of figures - save the old onesand put them in a clearely marked handle to use for heavire tasks) and infinite care/patience - take your time and keep the blade keen!
|
|